Towertalk
[Top] [All Lists]

Re: [TowerTalk] Interaction Question

To: Todd Coulter <coulter@bellsouth.net>
Subject: Re: [TowerTalk] Interaction Question
From: Joseph or Ruth Patrick <hdmc38@bellsouth.net>
Date: Thu, 10 Nov 2011 16:20:10 -0800 (PST)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Hello Todd

4' sounds real close but if you e-mail Tom DF2BO @  info@optibeam.de   he will 
have an answer. A very friendly guy. What type of height restrictions do you 
have? Are they legal? Or material.73 DE K4XZ Joe Patrick
God Made Man
Sam Colt Made Them Equal 




________________________________
From: Todd Coulter <coulter@bellsouth.net>
To: towertalk <towertalk@contesting.com>
Sent: Thu, November 10, 2011 11:22:34 AM
Subject: [TowerTalk] Interaction Question

I currently have an Optibeam OBW10-5, 5 band wirebeam. I would like to place a 
small 6m Moxan beam above it on the same mast. My only problem is that I only 
have approximately 4 feet of mast left above the wirebeam (due to height 
restrictions) and I can not lower the wirebeam any lower because it is already 
at the bottom of the mast and right above the top of the tower. I am wondering 
how much interaction all of you think I would have with this situation or maybe 
I should try a loop like the M2 HO loop instead. While I understand that the 
question(s) that I am asking probably requires modeling (which I do not have 
any 
experience with) to determine, I would like to solicit some of the experienced 
opinions here on TowerTalk. Thanks in advance for any opinions and advice 
given. 

 
73's
Todd
N4JRZ
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>