Towertalk
[Top] [All Lists]

Re: [TowerTalk] Guying a Universal Aluminum Tower

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Guying a Universal Aluminum Tower
From: K8RI <K8RI-on-TowerTalk@tm.net>
Date: Fri, 18 Nov 2011 18:22:54 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
On 11/18/2011 11:33 AM, n8de@thepoint.net wrote:
> I agree with Bill.
> Guys are NOT intended to be used with self-supporting towers, but ...
> can be used with much caution.

I'm not sure where my answer went to this but I'll try again.
One mistake that is so common most take it as being the right way is to 
tie the guy to a tower leg.  This should not be done.
The guy should tie to a "saddle, or bracket" that fits *around* the 
tower so the guys do not put any lateral pressure on the tower legs.
The guy tension will add vertical load to the tower legs just as if you 
had put additional weight on the tower at the guy point. This may exceed 
the towers dead weight limits.

> The reason the tower may 'sway' with winds after being up so long is,
> as Bill notes, probably due to distortion of the bolt holes due to
> stress.

Most self supporting towers and particularly Aluminum one sway quite a 
bit due to the elasticity of the tower itself.  They do not need 
elongated bolt holes to make them sway, although said holes will 
certainly accentuate the swaying and drastically reduce the towers 
ability to handle both weight and wind easily reducing the tower's 
ratings to a quarter of what it was when new and properly installed.

> You MUST re-tighten all the bolts AT LEAST ONCE per year!

Properly *torque* the bolts.
I am not using a self supporter (100' 45G), but I do check the bolts 
regularly. IIRC (this goes back a ways) Other than the first time I 
checked them I have never had to retighten those bolts again.  I do have 
to retension the guys though as I use elevated guy anchors. Even though 
they set in 17,000# of concrete (in clay) the anchor posts are very 
slowly tilting inward. (about 8" in a bit less than 10 years)


73

Roger (K8RI)

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>