Have you understood my question.?
I mean that hole in rotator plate. That hole, if I need to replace direction
sensor of rotator! How big a hole must be that I can, if necessary, replace
that sensor,without the need to bring down the entire rotator.
73 Mika oh6nvc
> On 12/17/2011 3:44 AM, Ian White GM3SEK wrote:
>>
>> Watch out for PST rotators in a tilt-over tower, because the water
>> shield over the top seal is only fully effective while the tower is
>> upright. If the tower is routinely tilted over for storms, it is
>> advisable to protect the rotator from driving rain.
>
> If you lay it over so the output shaft is horizontal any water that gets
> in should run right back out. I'd be more concerned about driving rain
> and wind with the thing upright. If water can still be trapped under
> that cover it could still suffer from the old problems.
>
> 73
>
> Roger (K8RI)
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|