Towertalk
[Top] [All Lists]

Re: [TowerTalk] Yaesu Rotor Bolt Pattern

To: <towertalk@contesting.com>
Subject: Re: [TowerTalk] Yaesu Rotor Bolt Pattern
From: "Chuck" <w5pr@swbell.net>
Date: Fri, 23 Dec 2011 12:09:25 -0600
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Thanks!

Chuck W5PR

----- Original Message ----- 
From: <MailfrmPA@aol.com>
To: <towertalk@contesting.com>
Sent: Friday, December 23, 2011 9:37 AM
Subject: Re: [TowerTalk] Yaesu Rotor Bolt Pattern


>I recently attached a Yaesu 1000 rotor to a Rohn 45 shelf and the holes
> were there and properly aligned.
>
>
> In a message dated 12/23/2011 10:22:13 A.M. Eastern Standard Time,
> w5pr@swbell.net writes:
>
> The  specs for the standard accessory shelf look to me like it is drilled
> for
> both Yaesu and Hygain rotors.  Here is the spec  sheet:
> http://www.3starinc.com/manuals/ROHN_AS25G.pdf
>
> Chuck  W5PR
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk  mailing  list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>