On 8/10/2012 7:00 PM, Jim Lux wrote:
> I agree. They galvanize 40 ft long I beams and other structural steel.
>
> You might need to call around
I haven't been able to find any within a reasonable shipping distance.
It's the girth that's limiting so far and I'm looking at several
thousand dollars round trip.
Has any one seen that huge crank up that was a Dayton the past few
years? I don't know if it was there this year. IIRC that was painted
and used rollers similar to what I want to do.
Are there any photos or listings of that thing on the net?
73
Roger (K8RI)
>
> On Aug 10, 2012, at 10:33, George Dubovsky <n4ua.va@gmail.com> wrote:
>
>> On Fri, Aug 10, 2012 at 1:11 PM, K8RI <K8RI-on-TowerTalk@tm.net> wrote:
>>
>>> On 8/10/2012 12:34 AM, K8RI wrote:
>>>
>>> Paint, in general, does not survive well under these conditions.
>>> Unfortunately I'm not left a lot of choice as the sections are far too
>>> big to have them galvanized (up to 4' on a face and 24-26 feet long)
>>>
>>> Actually, every galvanizer I've visited or talked to over the last ten
>> years has tanks at least that size. If you can haul it to them, they can
>> galvanize it.
>>
>> 73,
>>
>> geo - n4ua
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|