Towertalk
[Top] [All Lists]

Re: [TowerTalk] US Tower HDX-689 Sheave replacement

To: towertalk@contesting.com
Subject: Re: [TowerTalk] US Tower HDX-689 Sheave replacement
From: "larryjspammenot@teleport.com" <larryj@teleport.com>
Reply-to: "larryjspammenot@teleport.com" <larryj@teleport.com>
Date: Mon, 11 Mar 2013 07:16:25 -0700 (GMT-07:00)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Does that mean that the tower has to go back to UST to have such things 
installed? Just curious, before I look at spending lots of $$$$ for a tower 
that might need to have the same thing done a few years down the road. That 
could be VERY expensive!

LJ



-----Original Message-----
>From: K7LXC@aol.com
>Sent: Mar 11, 2013 6:53 AM
>To: towertalk@contesting.com, rich@n7tr.com
>Subject: Re: [TowerTalk] US Tower HDX-689 Sheave replacement
>
>>  Im looking for the 5 inch OD Pulley Sheave for the  HDX-689. This is for 
>the ? in cable.   I need to order a few of these  as I'm replacing all the 
>cables on the tower right now.  I know US Towers  had them, but wanted to 
>see if anyone else has replaced them from another vendor  for a better price.
> 
>    Typically these are UST proprietary. That is, they  make an aluminum 
>sheave and then press a sealed bearing into it. You'd have to  do the same 
>thing.
> 
>Cheers,
>Steve     K7LXC
>TOWER TECH
>US Tower factory authorized installer
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>