Towertalk
[Top] [All Lists]

Re: [TowerTalk] Crankup Danger

To: "'Bob K6UJ'" <k6uj@pacbell.net>, "'TOWERTALK@contesting.com reflector'" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Crankup Danger
From: "Wes Attaway \(N5WA\)" <wesattaway@bellsouth.net>
Date: Fri, 2 Aug 2013 09:39:26 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
You should stick a bar, pipe, or 2x4 thru the tower and under the bottom of
each section that you will be climbing on.


----------------- Wes Attaway (N5WA) ------------------- 
1138 Waters Edge Circle, Shreveport, LA 71106 
    318-797-4972 (Office) - 318-393-3289 (Cell) 
        Computer Consulting and Forensics 
-------------- EnCase Certified Examiner --------------- 

-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Bob
K6UJ
Sent: Friday, August 02, 2013 9:30 AM
To: TOWERTALK@contesting.com reflector
Subject: Re: [TowerTalk] Crankup Danger

Me again,
How do you guys with the motorized towers block your towers ?  I am thinking
of using 1 inch water pipe.
And where do you block it ?  Since it telescopes, do you you put blocking
through every section ?

Bob
K6UJ



On Aug 2, 2013, at 7:22 AM, Bob K6UJ wrote:

> Following this thread made me realize I will now block my motorized tower
before climbing.
> I have a US Tower HDX-589MDPL and I have been lowering it down till it
stops then climbing.
> But as pointed out, it is supported by the lift cable even when all the
way retracted.
> Thanks for the info guys !
> 
> Bob
> K6UJ
> 
> 
> 
> On Aug 2, 2013, at 6:53 AM, Patrick Greenlee wrote:
> 
>> 
>> Thanks for your response.
>> 
>> In my situation I have no zoning concerns, no inspections, no home owners
association, or such.  I am subject to FAA concerns if the tower is tall
enough (red and white alternating paint and lights.)  I do have neighbors
but the nearest are 1/4 mile away and not in the "kill zone" of anything I
would put up. I have a small black Angus cattle ranch (cow-calf operation)
on 160 acres so I can get pretty wild with sky wire and such if I want.
>> 
>> Patrick AF5CK
>> 
>> From: Bryan Swadener 
>> Sent: Thursday, August 01, 2013 7:12 PM
>> To: towertalk@contesting.com 
>> Cc: patrick_g@windstream.net 
>> Subject: Re: Crankup Danger
>> 
>> Patrick,
>> 
>> Yes and yes. I installed a 3-section 72 foot tower (US Tower TX472)
>> last July with the optional tiltover fixture. The tower manufacturer
>> clearly states that thou shalt not climb ye olde tower. In fact, with
>> motorized drive, I can have the tower up/down a lot faster than
>> I can climb it. Having it down and tilted over also means not having
>> to be concerned that I have all the parts and tools before climbing it.
>> 
>> My concern is the condition of your tower (mine came to me in perfect
>> shape) and the modifications to it.  If you are required to have a
permit,
>> your zoning and permitting agency may require wet-stamped plans for
>> your particular installation, from a Professional Structural Engineer who
>> is licensed in your state.  My county building department required it for
>> any tower structure over 35 feet tall that is not part of an existing
structure.
>> I hired Hank, KR7X and he supplied me with everything I needed.  I
>> suggest you look into the permitting requirements BEFORE investing
>> a lot of time/effort/money into your tower.
>> 
>> vy 73,
>> Bryan WA7PRC
>> 
>> Date: Thu, 1 Aug 2013 13:45:07 -0500
>> From: Patrick AF5CK
>> Subject: Re: [TowerTalk] Crankup Danger
>> 
>> Wouldn't you ordinarily lower a crank-up tower before climbing? If it
were a 
>> tilt over as well wouldn't you tilt it over instead of climbing it?
>> 
>> Patrick AF5CK
>> 
>> -----Original Message----- 
>> From: Wilson
>> Sent: Thursday, August 01, 2013 1:22 PM
>> Subject: [TowerTalk] Crankup Danger
>> 
>> Well, if the tower should telescope while you are on it, the shearing off
of
>> fingers and the front of your feet might be considered an undesirable
>> possibility.
>> If you are on an upper section when the collapse occurs, you might get by
>> with just some foot damage and being thrown to the ground as the section
you
>> are on drops into the next one down...
>> Your plan is much like the old EZWay towers.  There's a book for the two
>> section 40 footer on BAMA.
http://bama.edebris.com/manuals/ezway/rbs40
>> WL
>> _______________________________________________
>> 
>> 
>> 
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>