Towertalk
[Top] [All Lists]

Re: [TowerTalk] Towable towers available from the government

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Towable towers available from the government
From: Jim Lux <jimlux@earthlink.net>
Date: Thu, 15 Aug 2013 08:22:42 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
On 8/15/13 8:02 AM, k3mm@verizon.net wrote:
At least the tool cabinets can stay intact. Those are worth a few
dollars, but doesnt change the fact that this acquisition was a huge
waste of taxpayer dollars on both ends. I'm sure there are lots of
public service entities or other government agencies that would be
quite happy to have them for emergency communications.



Except there's visible rust on those tool cabinets.

I would guess that a speculative public service entity would spend more in labor costs assessing the condition and making repairs than it would cost to buy a new one with manufacturer's warranty and all new parts. It's different when it's a ham spending their own time, and assessing their own risk. A very different situation than an agency with legitimate safety and liability concerns.

Not to mention the whole additional cost of "parting out" the lot into separate lots. Preparing the lot probably takes an hour or two per lot, then the actual transfer paperwork probably takes a few hours per lot. It's not like it's a 15 minute job to have someone come down, verify the serial number, hook it up to tow vehicle and drag it out of there. More like 2 or 3 hours..

Then there's the transportation cost. Say you're an agency in New Jersey and you get one of those surplus towers from Alabama. How much does it cost to ship it? You're going to have to put it on a flatbed and haul it, or if you got lucky and its roadworthy (and licensed!) you pay someone to drag it 1000 miles.

There is a non-insignificant amount of paperwork associated with these surplus deals to make sure that there isn't fraud (Bob at the site marks those gold bars as "scrap iron", and tells his friend Dave to bid on it). That's why the "destruction/demil" requirement in many cases. If you're shredding it, there's no incentive to "throw away perfectly good equipment in the dumpster for a cohort to retrieve" (something that has occurred more than once).

It wouldn't surprise me to find that the labor time per transaction is in the 20-40 hour range.
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>