| To: | "towertalk" <towertalk@contesting.com> |
|---|---|
| Subject: | [TowerTalk] Crimp Sleeves |
| From: | "Wilson" <infomet@embarqmail.com> |
| Reply-to: | Wilson <infomet@embarqmail.com> |
| Date: | Sat, 28 Sep 2013 19:30:32 -0400 |
| List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
What’s the preferred material for crimp sleeves on EHS wire? I’m guessing copper, but haven’t found real instructions. Maybe zinc plated? Any favorite sources? I see them on Amazon. Wilson W4BOH _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] Fwd: Shielded shack, Jim Lux |
|---|---|
| Next by Date: | Re: [TowerTalk] Crimp Sleeves, W3YY |
| Previous by Thread: | [TowerTalk] Rohn 45-g flat top section rotor loop protection, GARY HUBER |
| Next by Thread: | Re: [TowerTalk] Crimp Sleeves, Hector Garcia XE2K |
| Indexes: | [Date] [Thread] [Top] [All Lists] |