Thanks Drax
There´s too much $$$ difference for example between 3 x IS-RCT (for 3
rotors) and 1 x 16 terminal ArraySolutions cable arrestor (for 3 rotors). I
think they do the same.
73,
Jorge
-----Mensaje original-----
De: Drax Felton [mailto:draxfelton@gmail.com]
Enviado el: domingo, 13 de octubre de 2013 08:43 p.m.
Para: 'Jorge Diez - CX6VM'
CC: 'TowerTalk'
Asunto: RE: [TowerTalk] Connecting Flat Copper to 5/8" Ground Rod
No you cannot do that. The device basically monitors each of the colored
wires for too high a voltage and shorts it to ground if it's too high.
It would be the same as trying to share the same cable with multiple rotors
the way the device hooks up.
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Jorge
Diez - CX6VM
Sent: Sunday, October 13, 2013 6:30 PM
To: 'Scott'
Cc: 'TowerTalk'
Subject: Re: [TowerTalk] Connecting Flat Copper to 5/8" Ground Rod
A good ground system is nice, and expensive. Is there any way to reduce
cost, por example, may I connect 2 or 3 rotor control lines (5 wires each)
to a single Polyphaser IS-RCT? So 2-3 wires will be connected to the same
terminal of the IS-RCT?
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|