Bend the top vertical with a piece of pipe.
Not sure if you can get the weld material level in the mold or not. Best
if the mold can be level or you will end up with a bad weld.
73
Jim W7RY
On 1/1/2014 9:22 AM, Mike Fahmie wrote:
How close to vertical must Cadweld One Shots be? I'd like to drive some ground
rods diagonally into the sides of my tower foundation hole but am concerned
that the One Shots might not function properly on a non-vertical rod.
-Mike-
WA6ZTY
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|