[TowerTalk] HG70HD pulley

[Mike Reublin NF4L <nf4l@comcast.net>]

While working on getting the new puppy ready for duty, I discovered the pulley 
at the top of the main section would not turn. I soaked it with PB Blaster and 
got it to go maybe 1/8 turn. 

I took it out, cleaned it well, put a little grease in the hole and put it back 
in. There is quite a bit of slop now on the axle.

Did I lose part of a bearing? Any suggestions for a fix or replacement?

73, Mike NF4L
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk