Re: [TowerTalk] Creating a Yagi Build Table with "Tape Measure" Dimensions

[Dan Maguire via TowerTalk <towertalk@contesting.com>]

Duh.  I completely forgot about changing the number format.  Thanks for the 
whack on the top of my head.  :)

There are some obscure reasons why that won't work if the build table is made 
part of an AutoEZ model, but in general it sure is easier than entering a long 
formula.

Dan, AC6LA

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk