The monofilament is quite light weight so use two strands. Tie a slipknot at
the copter and keep track of which line releases the knot. To release the
copter from the line, gently take a little tension on the "undoer" line and
then give a quick jerk to untie the knot.
73,
Patrick NJ5G
-----Original Message-----
From: Lew Sayre
Sent: Saturday, October 04, 2014 2:17 PM
To: towertalk@contesting.com
Subject: [TowerTalk] Quadcopter
Has anybody here devised a way to use a quadcopter with some sort of
release relay to put a light line over a tall tree for a wire antenna?
I've used a pneumatic gun in the past with great success but wonder if the
quadcopter might be a bit more accurate way to get maximum height out of
the tree.
Thanks,
73 and I remain,
Lew W7EW
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________
No infections found in this incoming message
Scanned by iolo System Shield
http://www.iolo.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|