Towertalk
[Top] [All Lists]

Re: [TowerTalk] rg-59 manufacturer

To: towertalk@contesting.com
Subject: Re: [TowerTalk] rg-59 manufacturer
From: "Joe Subich, W4TV" <lists@subich.com>
Date: Sun, 15 Feb 2015 20:18:49 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>

> Since I wrote my original message, I found some additional 59-SP coax
> that was purchased a year ago.  It exhibits the same 64-ohm impedance.
> From this, there appears to be a more fundamental problem and not an
> isolated batch problem.

I'd say the effective diameter of the stranded center conductor is a
bit larger than the solid center conductor and they did not change the
density of the dielectric to compensate.  That's nothing more than a
basic design error and goes to quality control.

73,

   ... Joe, W4TV


On 2015-02-15 8:04 PM, charlie carroll wrote:
Jim:
I'm not that far away from thinking the same thing.  However, I want to
call the distributor tomorrow and see what they say.  They're well known
in the ham community with a pretty good reputation.

Since I wrote my original message, I found some additional 59-SP coax
that was purchased a year ago.  It exhibits the same 64-ohm impedance.
From this, there appears to be a more fundamental problem and not an
isolated batch problem.

FWIW, I'm using the VNWA from DG8SAQ and ZPlot from AC6LA.  Great tools!

73 charlie, k1xx


On 2/15/2015 7:52 PM, Jim Brown wrote:
I'd say that you have lousy coax from a cheapo manufacturer with poor
quality control, and toss it in the trash.

73, Jim K9YC

On Sun,2/15/2015 3:11 PM, charlie carroll wrote:
I have some rg-59 that I want to use for phasing a couple antennas in a
low-power environment.  The 2 cables are marked as:

S.I.W TYPE RG-59/U-SP-95  MADE IN U.S.A

and

S.I.W TYPE RG-59/U-P-95  MADE IN U.S.A

I am looking for the manufacturer's data sheet to understand the
differences and characteristics of the cables.  The cable marked "SP"
actually has a stranded center conductor while the other is a solid
center conductor.

The big difference, however, is the impedance of the cable.  The "SP"
measures in the 63-65 ohm range with a VNWA, depending on which of
several I measure.  The solid-center version measures about 71 ohms on a
single sample.  The velocity factor is in the .64 to .66 range on all
cables.

Is there anyone that can point me to some data?

73 charlie, k1xx
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>