Re: [TowerTalk] Replacement Thrust Bearing

["Roger (K8RI) on TT" <K8RI-on-TowerTalk@tm.net>]

As my rotator is designed to run with a vertical load as are all the ham 
series that I know of.   I use the screws for alignment but never 
tighten them unless removing the rotator.On 4/17/2015 4:03 PM, Stan 
Stockton wrote:
73

Roger (K8RI)


> I've used these self aligning bearings similar to this for 40 years with very 
> large antennas and have never had an issue.  I have had issues with official 
> thrust bearings like TB3.  I usually put a heavy duty muffler clamp between the 
> top of the bearing and the antenna as I don't trust the set screws.
>
> http://www.bearingson.com/category/4-bolt_flanges/cast_iron_4-bolt_flanges/ucf_series/2_4-bolt_flange_bearings_ucf_210-32.asp?page=2&SortType=0
>
> I have never bought from this company but they are probably all alike in that 
> price range and made in China.
>
> I think I might buy the 2-1/16 one instead for a two inch mast.
>
> 73...Stan, K5GO
>
> Sent from my iPad
>
> > On Apr 17, 2015, at 11:49 AM, Robert Harmon <k6uj@pacbell.net> wrote:
> >
> >
> > I am overhauling my rotator and thought it would be good to replace my thrust 
> > bearing also.
> > I have the Rohn TB3 bearing now.  It has been in use for 18 years and feels 
> > pretty rough.
> > Im thinking of going with a different bearing this time with a steel body and 
> > greased. (grease fitting)
> > Looked thru the archives on tower talk to find out what others have used and 
> > can’t find much,
> > on this type of replacement and I know the bearing supply houses have them, just 
> > haven’t
> > pursued searching with them yet.   I would like to know what others have used.
> > If you have used a thrust bearing like this,  could you share
> > the number and supplier ?  Array Solutions has their model TB2 which is this 
> > type
> > of bearing but it only has a two hole flange for mounting.  They have a larger 
> > unit with a 4 hole
> > flange but it is for a larger diameter mast than 2 inch. I want a 4 hole flange 
> > but for 2 inch.
> > Here is the info from their webpage:   
> > https://www.arraysolutions.com/Products/thrustbearing.htm
> > Anyway, what say you ?
> >
> >
> > thanks,
> > Bob
> > K6UJ
> > _______________________________________________
> >
> >
> >
> > _______________________________________________
> > TowerTalk mailing list
> > TowerTalk@contesting.com
> > http://lists.contesting.com/mailman/listinfo/towertalk
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk

--

73

Roger (K8RI)


---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk