| To: | [email protected] |
|---|---|
| Subject: | [TowerTalk] Connector for Create rotator |
| From: | Grant Saviers <[email protected]> |
| Date: | Tue, 05 May 2015 11:57:22 -0700 |
| List-post: | <[email protected]">mailto:[email protected]> |
Need a source for the 7 pin Female cable connector for a Create
rotator. The pin arrangement is the same as for Yaesu BUT the threaded
shell is about 1mm larger so the Yaesu Nanoboshi NJC-207-PF connector
fits (pins and keys are the same) but won't screw on. I suspect this is
on purpose as the Yaesu uses DC for the motor and Create is AC. The
Create manual shows the part as 7-25.
Grant KZ1W _______________________________________________ _______________________________________________ TowerTalk mailing list [email protected] http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] Can Crimp connectors for RG-8 be used on RG-11?, Joe Giacobello, K2XX |
|---|---|
| Next by Date: | [TowerTalk] NOW: It's must be a U.S.Tower not a Wilson, Mike Bragassa |
| Previous by Thread: | [TowerTalk] Wilson tubular tower disassembly question, Mike Bragassa |
| Next by Thread: | [TowerTalk] Connector for Create Rotator, Tom-W3FRG |
| Indexes: | [Date] [Thread] [Top] [All Lists] |