Mike--
Since this happened just after Rotor work, I would suspect that as the
cause. Where is the Rotor with respect to the top?
I would take a close look at the Rotor body for any scratches, etc.
Bill--W4BSG
-----Original Message-----
From: Mike Reublin NF4L
Sent: Sunday, August 16, 2015 5:44 PM
To: towertalk reflector
Subject: Re: [TowerTalk] Binding tower
Anybody know a traveling tower mechanic?
73, Mike NF4L
On Aug 15, 2015, at 6:13 AM, Mike Reublin NF4L <nf4l@comcast.net> wrote:
I had the HG-70HD down to replace the rotor. When I put it back up, it
binds about 3 feet from full extension enough to stall the 24V wheelchair
motor that drives a Fulton #3000 winch.
I can't see any hang up thru binocs. When I collapse it, and tilt it
over, how do I find the jam, and how can I repair it? I don't have enough
room to extend it fully when it's horizontal.
73, Mike NF4L
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|