How about two SPDT relays and keep the spacing of the feedline?
Sent from my iPhone
On Sep 14, 2015, at 22:58, Lee <L@w0vt.us> wrote:
Have the relay spacing around an inch and the contacts good for 5 amps. Don't
hot switch when energizing the relay. You should have no problem with your
idea. Grounding or undgrounding the unused antennas may change your radiation
pattern depending on distance and coupling between antennas.
Lee, w0vt
> On 9/14/2015 8:51 PM, Rik van Riel wrote:
> Hello,
>
> I am considering building a remote ladder line switch using W199X-12
> relays, which are open frame DPDT with 1600V breakdown voltage between
> open contacts, 2200V between poles and coil/contact.
>
> I run with 100W power.
>
> Does anybody have opinions on relays like those, experience with them,
> or good experiences with other relays that you think I should
> consider instead?
>
> I am looking at switching between two lazy H antennas (one east/west,
> the other north/south) and maybe some doublets for lower bands.
>
> The plan is to have each antenna switched either to a 4:1 balun, or
> to ground. Would it make more sense to leave the unused antennas
> ungrounded, or discharge static through 1M resistors?
>
> thank you,
>
> Rik AB1KW
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|