I have owned four Yaesu G-2800 rotators and they all had Molex type
connectors not Jones. I purchased extra connectors and pins from Yaesu.
They were expensive but fit perfectly.
John KK9A
To: <[email protected]>
Subject: [TowerTalk] Need source for G-2800 controller connector
From: "bob" <[email protected]>
Date: Fri, 29 Apr 2016 09:24:00 -0500
List-post: <[email protected]">mailto:[email protected]>
I have a G-2800 rotator that I am pulling out of the closet to use and I
cannot find a source for the Jones type connector that is on the rotator
controller box (NOT the rotator end).
The connector has two rows of 3 horizontal pins with one of them
keyed/oriented 90 deg from the others. I have looked on Mouser/DigiKey and
while the have them with 6 pins in two rows, I cant find one with the one
pin keyed/polarized from the others?
Anyone have a source for them?
-bob, w9zv
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|