Check your local machine shops. They can probably make one for less
that the LM470 replacement cost.
Is the bushing shot? If so, the machinist can probably fit a sealed
bearing in place of the bushing.
73
Roger (K8RI)
On 9/2/2016 Friday 8:27 AM, Glen Turner wrote:
Gentlemen;
I realize this is a long shot, but I am in need of ONE sheave for my LM 470
tower. They all appear to be the same size. Anybody have one laying around
or know of a reasonable off the shelf source? Have got a call into Tash
Towers.
Glen W5IF
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|