I though anodising had a problem with surface currents?
Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10
From: Michael Clarson<mailto:wv2zow@gmail.com>
Sent: Tuesday, 1 November 2016 11:02 AM
To: Bill Hein<mailto:bill.aa7xt@gmail.com>
Cc: TowerTalk@contesting.com<mailto:towertalk@contesting.com>
Subject: Re: [TowerTalk] Crowd sourcing ideas on making antennas look better
Bill: How about Anodizing? If not a choice, it should at least make the
list. --Mike, WV2ZOW
On Mon, Oct 31, 2016 at 4:21 PM, Bill Hein <bill.aa7xt@gmail.com> wrote:
> This is Bill from Force 12.
>
> Had a customer ask about making a vertical antenna look nicer. Most of us
> know that 'mill finish' aluminum tubing - as is typically used in antenna
> construction - may have scratches and blemishes, which don't affect
> the electrical performance but might have a cosmetic impact when viewed up
> close.
>
> Power coating looks great but is not inexpensive. Spray painting works fine
> at HF frequencies if one is careful to mask the overlapping conductors
> before painting. Are there other viable options short of painting to treat
> the aluminum tubes?
>
> 73
>
> BIll AA7XT
> Glade Park CO
> DM59pa
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|