I had a low horizontal 160 dipole stretched across my property and it was
no good. Robin WA6??? suggested it because they had one in Burma and it was
a good RX antenna.
But YMMV...
73 N7RT
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Jim
Thomson
Sent: Tuesday, January 17, 2017 12:32 PM
To: towertalk@contesting.com
Subject: [TowerTalk] 80m rotary dipole for 160M RX ?
Has anybody tried using a 80m rotary dipole as a 160M RX ant ? Im
thinking it may well be quieter
than any dedicated RX ant I could come up with....on a city lot. There is
no way I can get adequate
separation between any 160m TX ant, like a .25 wave sloper, shunt fed
tower,etc, and a 160M RX array.
This assumes plenty of Z and esp RS on the 80m 1:1 choke balun... when used
for 160M RX. I dont use
QSK, just vox. So I would have to incorporate some high speed vac relay
setup to swap ants when on 160M RX.
It would be interesting to know if the RX concept even works. 80m rotary
dipole planned to go up this spring, on the crankup..at 100 ft.
Jim VE7RF
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|