Directive systems does not list windload for there antennas? Mike
-----Original Message-----
From: n8de <n8de@thepoint.net>
To: mikflathead <mikflathead@aol.com>; mike repinski via TowerTalk
<towertalk@contesting.com>
Sent: Sat, Feb 25, 2017 4:15 pm
Subject: Re: [TowerTalk] question for the group
What must be considered is NOT the weight of the antennas, but the
wind load and torque load.
Tailtwister will turn the whole thing with no problem.
What is the windload of the antennas and the tower rating? Those are
what should concern you.
Good luck .. I have a lot of those self-supporting aluminum towers.
They perform well when antenna load ratings are less than the tower
specs.
73
Don
N8DE
Quoting mike repinski via TowerTalk <towertalk@contesting.com>:
> I would like to run this by the group. I presently have a self
> supporting 50 foot aluminum tower with a 6 element 6 meter beam.
> What I would like to do is hang 2 pieces of tubing from the boom
> each side of the mast and mount some loop yagis for 902, 1296 and
> 2304. My thought is to form a square that would clear the tower
> section by an inch or so. The loopers would mounted off this "box".
> Hopefully this makes sense. The rotor is a tail twister. The
> antennas add up to 44 lbs not including any framework. Mike
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|