Towertalk
[Top] [All Lists]

Re: [TowerTalk] Winds

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Winds
From: Patrick Greenlee <patrick_g@windstream.net>
Date: Tue, 16 May 2017 13:39:03 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Most winds in general are horizontal with lower levels of the wind in contact with the ground, trees, and other drag inducing objects which slow the lower level wind through friction and turbulence. Slopes more or less facing broadside to the oncoming wind can accelerate the wind as more wind is passing through the same cross section. Often a ridge more or less at right angles to the wind will act similar to an airplane wing where the wind over the top is accelerated and moves faster than the air before feeling the effect of the ridge.

Patrick        NJ5G


On 5/16/2017 11:42 AM, Bill via TowerTalk wrote:
My place out in KH6 is an example of how much stronger the wind is up top.

I live on a very steep slope facing the tradewinds, which normally blow at an 
average of 12-15 MPH.  When it is blowing this hard it is impossible to raise 
or lower antennas.  So any raising or lowering must be done at lower speed 
levels.

Why, when the wind is only 5-6 MPH it is usually closer to 15 MPH at the top of 
a 90 foot tower.  It is amazing how at the base you feel almost no wind but it 
quickly picks up once you get about 20 feet or so.  I've had many 200 ft towers 
on the mainland but have never experienced such a big difference in surface and 
top of the tower speeds.

Being on a steep upslope is the reason, I'm sure.

73  Bill KH7XS
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>