Towertalk
[Top] [All Lists]

Re: [TowerTalk] Trenching & PVC

To: <w1pdi@aol.com>
Subject: Re: [TowerTalk] Trenching & PVC
From: "Gene Smar" <ersmar@verizon.net>
Date: Sun, 28 Jan 2018 22:36:14 -0500
List-post: <mailto:towertalk@contesting.com>
Tom:

     I can offer a solution for one of your issues.  If you can fit it in, 
instead of a 90-degree elbow, install a pullbox.  That'll give you sufficient 
room to pull the cable into the box then make the turn inside the box and 
continue on to the tower.  

     Good luck with the project.

73 de
Gene Smar  AD3F
  

-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of w1pdi--- 
via TowerTalk
Sent: Sunday, January 28, 2018 8:10 PM
To: towertalk@contesting.com
Subject: [TowerTalk] Trenching & PVC


I’m finalizing my list of what’s needed for my tower projectand what needs to 
be done either before or after the tower is up.
 
Routing of 4 coax and rotor cable has to be decided. Eithertrench approx. 125 
ft from base of tower to house entry point where there’s asharp 90 degree turn 
from behind the detached garage where the tower will be for20ft, the sharp 
angle then straight to house entry point 105ft away.
Potential trouble with this route 1): 90 degree turn asmentioned and because 
the neighbor’s property line is so close I can’t make ita sweeping turn.
2) Garage gutters run into n in ground PVC storm drain pipethat runs towards 
the front of house in the same direction as coax and cablewould run. We’re not 
sure yet where this drain system is located but trenchingfor Coax/cable PVC 
could become an issue.
3) Tree roots from an oak and maple tree are in the pathabout 35 to 40ft from 
the 90 degree turn.
 
I suggested one option that was shot down by a few and thatis run coax and 
cable off tower through the length of garage (38ft) and exitopposite side of 
garage then trench and bury thru PVC for about 50ft.
 
Any problems in routing thru garage?
Also, will regular 3” PVC piping be OK? The gray electricalgrade would be nice, 
and expensive.
Should the PVC with drain holes be the right selection?
Buy solid PVC and drill my own drain holes in it?
 
Advice would be appreciated.
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>