| To: | Jim Thomson <[email protected]> |
|---|---|
| Subject: | Re: [TowerTalk] Connectors, Installation, Bury-Flex, etc., |
| From: | Edward Mccann via TowerTalk <[email protected]> |
| Reply-to: | Edward Mccann <[email protected]> |
| Date: | Tue, 26 Jun 2018 10:42:08 -0400 |
| List-post: | <mailto:[email protected]> |
In the simplest of terms, it sounds like the dielectric grease is notionally conductive, as opposed to acting as an insulator. Is this a correct conclusion? 73, AG6CX Sent from my iPhone > On Jun 26, 2018, at 10:37 AM, Jim Thomson <[email protected]> wrote: > > What does work is to use a TINY layer of dielectric grease, like dow > corning DC-4 or DC-5 or most other versions of dielectric grease on the > center pin, and also the threads. _______________________________________________ _______________________________________________ TowerTalk mailing list [email protected] http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] N connector, Re: UHF (PL259) soldered center with braid crimp or, crimp-crimp, supply?, jimlux |
|---|---|
| Next by Date: | Re: [TowerTalk] N connector, Re: UHF (PL259) soldered center with braid, jimlux |
| Previous by Thread: | [TowerTalk] Connectors, Installation, Bury-Flex, etc.,, Jim Thomson |
| Next by Thread: | [TowerTalk] N connector, Re: UHF (PL259) soldered center, Jim Thomson |
| Indexes: | [Date] [Thread] [Top] [All Lists] |