Towertalk
[Top] [All Lists]

Re: [TowerTalk] JK 402 versus CC XM-240

To: towertalk@contesting.com
Subject: Re: [TowerTalk] JK 402 versus CC XM-240
From: Grant Saviers <grants2@pacbell.net>
Date: Wed, 27 Feb 2019 09:55:25 -0800
List-post: <mailto:towertalk@contesting.com>
A 27 MHz modest dip is real. At one time I considered other antennas on the same mast and modeling showed little interaction. Mine was 11' below a 86' Tornado tuned 80m dipole (EF180C reworked) element parallel and there was no interaction that I could measure.

Those antennas are on a HDX589. I use a boom lift. The other one I built went up with a crane. It's over 7ft between the inside of the T elements so with care on a calm day it should go on a side mount from a tram or crane. A tilting boom might be a way to assemble the elements on the tower.

It fits in about a 50ft square.

Grant KZ1W



On 2/27/2019 8:22 AM, john@kk9a.com wrote:
There is no question that the 40m Moxon is a great design however it is not a small 40m beam and as you mentioned it can be difficult to install. Side mounting them might be a real challenge. I wonder how the Moxon gets along with other antennas?  From my NEC2 model (which is inaccurate for this design) it appears to be resonant on ~27 MHz.

John


Tom W2SC wrote:

As Grant indicates, I use two W6NL Moxons at 8P5A.  They are on different towers and are not phased.

Overall, I could not be happier with them.  While I do not have an antenna testing range, they seem to have a discernible pattern across the whole band an have an SWR below 1.4:1 at the band edges.  I seem to be able to work people with them

The prior antenna was a 3L Hygain that I struggled to keep working.  I took the driven element down at least 30 times.  Plus, it was not clear how broadband it was, either in terms of pattern, and certainly not in the case of SWR.

I can’t speak to the JK antenna, but the W6NL has held up well so far in a very corrosive, but no ice environment. With the Tbars it is not an easy antenna to install without a crane.  Twisting it up through the guy wires was extremely difficult and required some steps I would not recommend.

Thanks to W6NL for his technical contribution

73 Tom W2SC 8P5A
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>