Great thanks,
I am working on it now.
Thanks,
Will
K6ND
-----Original Message-----
From: Steven Katz <[email protected]>
Sent: Tuesday, May 21, 2019 2:21 PM
To: [email protected]; [email protected]
Subject: RE: [TowerTalk] A50-6S Dimension SET
It's in the same manual, in TABLE 1, a few pages earlier.
SET for horizontal polarization and 50-51 MHz tuning = 17-7/8"
X under same conditions = 3-3/4"
-----Original Message-----
From: TowerTalk <[email protected]> On Behalf Of
[email protected]
Sent: Tuesday, May 21, 2019 11:16 AM
To: [email protected]
Subject: [TowerTalk] A50-6S Dimension SET
I bought a used A50-6S 6 meter beam in Dayton, the antenna is complete and
is now assembled.
I have some trouble to get the antenna resonant, I think it is because I
don't have a dimension for the "Reddi-Match". The tuning strap was/is not at
the correct place.
I am looking for the "SET" dimension as stated on page 5 of the manual.
Thanks,
Will
K6ND
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|