Not to answer your question directly, but if it were me I'd forget about
swaging anything and just shim it. And I have done so on several
occasions. Worked out fine.
73 Don
VE6JY
On Tue, Mar 17, 2020 at 3:47 AM KIRBY NESBITT <k.nesbitt@shaw.ca> wrote:
> I'm getting ready to refurbish an HF beam (Force 12) once/if the snow ever
> melts, and am going to have to replace a section of one element. Has anyone
> found a relatively inexpensive swaging tool for aluminum tubing?All that's
> showing up on my search is some fairly heavy duty industrial style
> equipment. Only looking to do two joints on the one element so don't want
> to invest allot of money into a fancy piece of equipment.Regards,Kirb -
> VE6IV
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|