For smaller cable, maybe up to 1/4", I wrap several layers of black tape
around it an inch or so long.
I place the tapped section of cable on a backup block of steel then use a
sharp, large chisel and hit/cut the cable at the tape point with a good
sized hammer.
Generally, it make a good clean cut.
Ray
N6VR/W7YA
On Sun, Jun 28, 2020, 7:31 PM <john@kk9a.com> wrote:
> For 1/4 or 5/16 EHS, I tape the area with reinforced strapping tape and cut
> though center of the tape with bolt cutters. This is very quick and easy.
> The strands on both ends are contained and ready for use.
>
> John KK9A
>
>
> Phil W5BVB wrote:
>
> Any recommendations? I was thinking about taping
> the place for the cut with electrical tape and then
> wedging it in a piece of copper tubing....
>
> thanks, 73, Phil W5BVB
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|