| To: | [email protected] |
|---|---|
| Subject: | Re: [TowerTalk] Yaesu 2800DXA |
| From: | Jim Brown <[email protected]> |
| Reply-to: | [email protected] |
| Date: | Wed, 21 Apr 2021 20:39:50 -0700 |
| List-post: | <mailto:[email protected]> |
On 4/21/2021 7:43 PM, Keith Dutson wrote: Likely the current draw in colder weather is dropping voltage below rotor requirement. So, I would increase the wire to 2x14 and 6x18. I would beef up only the motor conductors. The location conductors (the smaller gauge) are only sensing the position of a pot. 73, Jim K9YC _______________________________________________ _______________________________________________ TowerTalk mailing list [email protected] http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] Yaesu 2800DXA, Steve Jones |
|---|---|
| Next by Date: | Re: [TowerTalk] Yaesu 2800DXA, Nidhog |
| Previous by Thread: | Re: [TowerTalk] Yaesu 2800DXA, Nidhog |
| Next by Thread: | Re: [TowerTalk] Yaesu 2800DXA, Joe K2UF |
| Indexes: | [Date] [Thread] [Top] [All Lists] |