Hello Talkians!
I am starting the foundation/ground work for a modest Rohn 45G tower
(60'). To make extra use as a radiator I was planning to insulate the
concrete base from the bottom section(pier bin base) with something flat
and high compressive strength (1/2" HDPE, UHMW or even fiberglass sheet).
A small insulated ring would also be needed around the pier pin to
prevent it from direct contact as well.
Tried searching the archives but I couldn't find an answer :( -- I believe
this has been done in similar fashion with 25 towers with a tilt base plate
and concrete anchors.
Appreciate any comments, ideas or experience with this (or even telling me
I am completely out to lunch)
Thanks :)
Jessy VE4JBB
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|