Visible "conductor are oxidized, stained or tarnished" is bad news, highly
suspect remaining moisture within.
Moisture within any feedline is trouble.
Thanks n 73,
James
ki5dq
On Saturday, July 24, 2021, 12:36:08 PM CDT, Jon Zaimes via TowerTalk
<towertalk@contesting.com> wrote:
Two tests I use for newly acquired used hardline .....
With nothing connected to the other end, measure resistance with VOM. It should
be open. Anything else, there is a problem.
Then I test with the TDR function on my AA-230 Zoom antenna analyzer. Normally
two flat lines near center scale but if a problem it will show otherwise. It
may show distance to a specific fault.
73/Jon
Jon P. Zaimes, AA1K Tower climber for hire http://www.aa1k.us/ Cell:
302-632-2353email: jz73@verizon.net or aa1k@arrl.net
-----Original Message-----
From: trentkd5ia--- via TowerTalk <towertalk@contesting.com>
To: towertalk@contesting.com <towertalk@contesting.com>
Sent: Sat, Jul 24, 2021 1:30 pm
Subject: [TowerTalk] Heliax question
I have a length of 1 5/8” air dielectric Heliax. When I cut it to install a
connector, the outside surface of the inner conductor and both inside and
outside surfaces of the outer conductor are oxidized, stained or tarnished.
So, is it usable or am I just wasting my time working on it?
Thanks and 73 de Trent K5XM
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|