Sure, I turn RG217 and LCF12-50 on Versatower crank-up.
Use also RG218 as rotator loop on fixed tower.
73
Peter DJ7WW
-----Original Message-----
From: TowerTalk [mailto:[email protected]] On Behalf Of
[email protected]
Sent: Donnerstag, 7. Oktober 2021 23:44
To: [email protected]
Subject: Re: [TowerTalk] Kellums Grip for supporting cables aat tower top
Probably tape and some good cable ties would work. I am wondering if RG217
is flexible enough for a crank-up tower and rotator loop?
John KK9A
N6TA wrote:
I know what they are and do not need one for pulling thru conduit. But I
would like a clean way to support the 70' of cable going up to the top of my
DX-70 telescoping tower.
The question is if it is bad form to put more than one cable into the grip.
I understand that the braid will not fully contact any one cable. The only
reason to consider mor than one per grip is that they seem to cost over $30
each.
Any alternate common method to support cables would be appreciated. I
suppose good tape on top section is always an option. Using one RG217, one
rotator cable and one 24 conductor for DB36 control.
Thanks.
Al
N6TA
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|