Anyone out there proficient with YagiStress who could give me a little
help. I want to check some numbers before cutting tubing to make some 40m
verticals and unfortunately don't have the software with me on this
computer. Not looking to withstand a hurricane but might as well make it
as good as possible, preferably without double walling anything. Tried to
use the trial version of Yagi Mechanical but without reading instructions
couldn't figure out what to do. Could use YagiStress in my sleep after
using it for perhaps 500 hours over the last 30 years..
These numbers add to 36.5 feet. I can make any of the 33 inch pieces 69
inches. The only one that might be fixed is the 1.75. I think I have
about 5-6 feet of it.
1.75 .200 30 30
1.50 .058 69 72
1.375 .058 33 36
1.25 .058 33 36
1.00 .058 33 36
.875 .058 33 36
.75 .058 33 36
.625 .058 33 36
.500 .058 69 72
.375 .058 69 72
Hoping someone can give me some help.
Thanks...Stan, ZF9CW
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|