| To: | [email protected], John Birken <[email protected]> |
|---|---|
| Subject: | [TowerTalk] Increasing the Inside diameter of a 1 inch outside diameter Alum pipe. |
| From: | John Birken <[email protected]> |
| Date: | Wed, 31 Aug 2022 03:40:52 -0400 |
| List-post: | <mailto:[email protected]> |
I need to increase a beam section inside diameter about .06 inch. The outside diameter of this Al pipe is1 inch. Mosley was not receiving the element section for a few months. Amazon had the right Al inch pipe made by an antenna company. The new 6 foot long section needs to slide in 12 inches to the thinner section. The pipes won't slide together because the new pipes ID is a little too thick . Thanks for advice, John, K2SFS _______________________________________________ _______________________________________________ TowerTalk mailing list [email protected] http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] Re New product idea, Jim Brown |
|---|---|
| Next by Date: | Re: [TowerTalk] Increasing the Inside diameter of a 1 inch outside diameter Alum pipe., Jim W7RY |
| Previous by Thread: | [TowerTalk] WTB: Fiberglass Poles, Edward via TowerTalk |
| Next by Thread: | Re: [TowerTalk] Increasing the Inside diameter of a 1 inch outside diameter Alum pipe., Jim W7RY |
| Indexes: | [Date] [Thread] [Top] [All Lists] |