DXE mast load estimator is back online. Sorry for the interruption
https://www.dxengineering.com/mastloadestimator
73
Tim K3LR@DX Engineering
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of john
simmons
Sent: Tuesday, May 28, 2024 4:08 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Mast material question
Mark,
DXEngineering has a mast load calculator (offline as of this moment).
Although I'm not answering your question directly, many here will have a
good 'seat of the pants' feeling if you tell us what antennas and what
heights you are planning for.
73
-de "Curly" John NI0K
QRZ.com<https://www.qrz.com/db/ni0k>
Hamshack Hotline<https://hamshackhotline.com/> call me: 6100000271
On 5/28/2024 8:39 AM, Mpridesti via TowerTalk wrote:
Looking to purchase a mast that was quoted as:
CRT 2 inch OD x 0.25 wall by 20 ft DOM
Not galvanized as yet.
Will this be near equivalent to Chromoly?
A modest antenna load is planned- wind surface area.
Regards,
Mark, K1RX
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com<mailto:TowerTalk@contesting.com>
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|