[AMPS] Re: Low Output on 10 meters

Jan-Erik Holm JEH@on.mobile.telia.se
Thu, 27 Aug 1998 08:43:56 GMT+1


>
>Re tuning the input networks on any GG amp:
>
>I know this has been said before, but I'll say it again.
>
>First determine the cathode impedance of the tubes in your amp. Ask
>somebody, look it up, or calculate it if you're into S&M.
>
>Take a small carbon or good metal film resistor of a value equal to the
>combined impedance of the tubes in you amp and tack solder it from the
>cathodes to ground.
>
>Do not even plug your amp into the AC mains. Just stick your favorite
>impedance bridge onto the input connector, jam the relays over if
>necessary, and tune away. No HV, no hassle, no problem. Be sure to take out
>the resistor when you are finished.
>
>Been doin' it that way for about 30 yrs now, never missed the mark yet.
>
>73,
>
>Larry - W7IUV
>
>--
I´ve done the same for years and years and
it works just great.

73, Jim SM2EKM


--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm