[AMPS] Low Output on 10 meters

Jon Ogden jono@enteract.com
Thu, 27 Aug 98 09:54:20 -0500


>Take a small carbon or good metal film resistor of a value equal to the
>combined impedance of the tubes in you amp and tack solder it from the
>cathodes to ground.

Tubes also typically have an input capacitance that needs to be accounted 
for in the matching network design.  So you may need to run a good mica 
cap from the cathode pin to ground as well.  This would give you the most 
accurate match.

73,

Jon
KE9NA


--------------------------------------------------------------------------
Jon Ogden

jono@enteract.com
www.qsl.net/ke9na

"A life lived in fear is a life half lived."


--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm