[AMPS] High Power Supply Question

[George McCrary]

Hello Folks,

	I'm in the process of building a 3-500 amp from the dregs of
someone elses earlier project. I have the power supply built, but the
power transformer I used was designed for 220 VAC nominal rather than
the 240 (plus) that I have at my outlet.

	The problem is that with a standard capacitor input filter my
no-load voltage is around 4300 VDC, which is a bit high for a pair of
3-500s.

	Using a variac I have determined that 220 VAC gives me 4000
VDC no load. With the voltage dropping to 3400 under load.

	Short of using a variac is there any practical way to lower
the primary voltage?

	I have tried using a choke input filter, but my loaded voltage
was only about 2700 VDC, which is less than I would like.

					Regards,

					George (KQ4QM)



--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm