R: [AMPS] 8877 bias

[Maurizio Panicara]

Once I tried something similar to avoid using large zener diodes.
I didn't like very much the performance of several direct polarized diodes
in series to establish a voltage.
I had much better results using little bit more elegant circuit (my opinion)
that used a cheap 2N3055 (with heatsink) and a 7.5 V zener diode.

73,
Mauri I4JMY


-----Messaggio Originale-----
Da: measures <measures@vcnet.com>
A: Alek Petkovic <vk6apk@eon.net.au>; AMPS <amps@contesting.com>
Data invio: domenica 19 dicembre 1999 17.46
Oggetto: Re: [AMPS] 8877 bias


>
> >
> >Dick, throw those expensive zener diodes back in the junk box and use a
> >string of forward biased 1N5408's and then tap off the volts you need to
> >get the desired idle current.
> >
> >It's the cheapest and easiest method I know of. You can even wire them to
a
> >multi position switch to select the correct voltage.
> >
> Amen, Alek.
>
> -  Rich..., 805.386.3734, www.vcnet.com/measures.
>
>
> --
> FAQ on WWW:               http://www.contesting.com/ampsfaq.html
> Submissions:              amps@contesting.com
> Administrative requests:  amps-REQUEST@contesting.com
> Problems:                 owner-amps@contesting.com
> Search:                   http://www.contesting.com/km9p/search.htm
>


--
FAQ on WWW:               http://www.contesting.com/ampsfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm