[AMPS] stability tests

[Tom Rauch]

Varying the tuning cap does indeed help check for VHF 
oscillations, because the tuning cap greatly changes the anode 
load impedance at VHF.

Varying tank components on the load side of the tank does not 
change VHF impedance a significant amount, because of the low 
pass filter effect of the tank.

To test for HF stability you need to move the input and output 
impedances through all load resistances and reactances, including 
those below the operating frequency.

That's because the input and output networks are transparent at 
low frequencies.

Raising HV about 25% above normal, if safely possible, is a good 
idea. It's also a good idea to check at low plate current bias, and 
near rated dissipation.

I've never found a PA that would pass these tests and oscillate in 
the real world end-use. 

By the way, if you have Clipperton L or other amplifier that is un-
neutralized and uses 4 572 or 811A tubes in parallel, don't try 
these tests without safety glasses. The HF oscillations will cause 
components to fail.


73, Tom W8JI
w8ji@contesting.com

--
FAQ on WWW:               http://www.contesting.com/ampsfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm