[AMPS] Tuned input

[Phil Clements]

Here is what the manual says:
Maximum drive power: 150 watts
Grid current, never exceed: 200 ma
If plate current exceeds 1 amp, it will be impossible
to see a dip when tuning. Tune for maximum power out
without exceeding 200 ma grid current.
If the above limits are observed, the tubes will last
a long time, which is good, for they are on the endangered species list! (8875)
Have fun...and good DX!
Phil, K5PC


Phil Clements
410 VZ CR 4903
Ben Wheeler, TX 75754

----- Original Message -----
From: <Km8i@aol.com>
To: <amps@contesting.com>
Sent: Monday, July 09, 2001 12:09 PM
Subject: [AMPS] Tuned input


>
> A friend of mine recently purchased a Dentron MLA-2500.  In the archives I
noticed some one had asked about this amp before, but I could not find the
answer to this question.  Since the MLA-2500 does not have a tuned input what
percautions are necessary to use it with a solid state rig.
>
> As you can probaly guess I am not very familiar with amplifiers or their
construction, but am planning to rectify that with some studying on the subject.
>
>     TNX & 73,
>
>       Jim KM8I
>
> --
> FAQ on WWW:               http://www.contesting.com/FAQ/amps
> Submissions:              amps@contesting.com
> Administrative requests:  amps-REQUEST@contesting.com
> Problems:                 owner-amps@contesting.com
>
>



--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com