[Amps] MLA2500 power up......

[2]

Disconnect the hv from the 8875s,  If it stops blowing fuses, the problem 
is inside the tubes.  To test the tubes for current leakage, use a 
high-pot tester set to 5kV.  Anything over 10uA-cold anode-grid is not 
good news. 

>My MLA keeps blowing fuses at power up....  It's done this before but
>"fixed" itself after a short bit.  Not this time.  Any suggestions? (other
>than buy a real amp.....)
>
>Blake N4GI
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
>


-  R. L. Measures, a.k.a. Rich..., 805.386.3734,AG6K, 
www.vcnet.com/measures.  
end