[Amps] Re: SB-220 on 220V

[Michael Tope]

Roughly Zero Volts DC - since the neutral and safety ground
are connected together at the AC mains service entrance.
If you want to do things per NEC, you aren't supposed to
let the chassis connection carry any return current, therefore
the neutral wire shouldn't be connected to chassis if its
also carrying load return current (as in the case of the Henry
2K-D). If you don't give a hoot about NEC, then you can run
the load return current through the third wire chassis
connection if it makes you happy. Even if its a green wire,
the electrons won't care (unlike a building inspector).

73 de Mike, W4EF.................................................

----- Original Message -----
From: <rlm at mail.somis.org>
To: "Michael Tope" <W4EF at dellroy.com>; "Dave Haupt" <emailw8nf at yahoo.com>; "
AMPS" <amps at contesting.com>
Sent: Sunday, December 07, 2003 12:02 AM
Subject: Re: [Amps] Re: SB-220 on 220V


>
>
> >I agree with Dave. I recently wired an SB-221 for
> >240V service. It was wired exactly as Dave
> >describes (third wire is chassis to AC
> >mains safety ground connection). There is no
> >connection between the amplifier and the AC
> >mains neutral.
>
> **  If there is no connection between the two. what is the potential
> difference between the neutral and ground?
>