[Amps] Use of stainlees steel in RF environment
Phil Clements
philk5pc at tyler.net
Fri Feb 28 11:09:58 EST 2003
> I have been told by Amp building Elmer that it is highly unacceptable to use
> stainless steel hardware in a RF enclosure. I was planning on using SS
> screws in many places in close proximity to the 3CX3000 that I am building.
> He said that I should use brass only. Is this correct?
>
I have seen and played with many commercial grade amps and RF generators
over the years, Bob, from several different manufacturers. They all used brass
hardware throughout the RF deck. Your Elmer is probably correct.
(((73)))
Phil, K5PC
More information about the Amps
mailing list