[Amps] Power supply design considerations

[tongaloa]

Kings electronics makes them and allied stocks.
SHV 5KV DC.
Cost you under $100 for two chassis mount and two plugs.
They have some good to 30KV DC
-bob

George & Marijke Guerin wrote:

>Jim, et. al.,
>
>    For HV insulated wire go to a neon sign company.  They typically have
>rolls of very wiring in 14 gauge with 15KV insulation or better. I was given
>some 3 foot scraps from a field installation for rewiring inside a Drake L7
>power supply.  By the way, I have not found a connector good for more than 3
>KV.  The Millen unit can leak around the HV wire at higher voltages.  I
>would put a gromet in a chassis panel hole and pull the wire through to a
>well insulated terminal strip at each end. 
>