[Amps] Dx pedition amp ???

[Dr. William J. Schmidt, II]

Yeah... you are on the right track.  An SGC power cube-like amp with a good 
(no noise) switching power supply might be a good answer

Sincerely,

Dr. William J. Schmidt, II  K9HZ
Trustee of the North American QRO - Central Division Club - K9ZC

"Collector of Edison Wind-up Phonographs... Do you have one for me?"
Email: bill at wjschmidt.com
Alternate Email: wmschmidt at charter.net
WebPage: www.wjschmidt.com



----- Original Message ----- 
From: "Steve Thompson" <g8gsq at ic24.net>
To: "Josh" <xppq at ispwest.com>; <Amps at contesting.com>
Sent: Thursday, December 02, 2004 2:21 AM
Subject: Re: [Amps] Dx pedition amp ???


> Josh wrote:
>
> snip
>> I wish there was  a two part amp  with PS
>> separate that could be under 30 lbs and
>> output at least 600w  on CW
> You can get a 600W broadband amp kit from CCI. The pcb is about 6 x 4". It
> needs harmonic filters, but I'm sure I've seen someone refer to a switched
> set you can buy if you don't want to build. Add a modern switch mode PSU,
> and you can have a travel amp that will weigh very little and be not much
> bigger than a shoe box. I bought a 500W PSU a few days ago for a job - 
> when
> I went to pick it up I thought they'd given me the wrong one - about 6 x 5 
> x
> 4", and 4lbs! Cost about $420.
>
> Steve
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>