[Amps] Al 572

wb8jkr at juno.com wb8jkr at juno.com
Wed Dec 22 04:48:38 EST 2004


 Don't know where they're made, but I've used
the TAYLOR 572-B's here in a SB-200 for
a few years and have had no trouble at all.
 Have also used them as replacements for others
amplifiers on a few occasions and all have
worked fine, the last set being purchased about
2 1/2 years ago.

Mark  WB8JKR

On Tue, 21 Dec 2004 21:08:18 -0800 (PST) Joe Isabella <n3ji at yahoo.com>
writes:
> Okay...  There *ARE* issues with 572Bs -- I'm not an expert on those, 
> though.  I've always had 3-500s.  Good luck!!
> 
> 
> larry williamson <lgwsaw at worldnet.att.net> wrote:
> Sorry I did not say the kind of amp.... It is a AL 572... Only about 
> 8 months old. I just tonight installed the new 51 ohm resistor and 
> one new tube form ameritron. Only tried about a 10 minute chat on 
> 160 and it seemed to be ok. I will run it more over the next few 
> days and see what happens. Both times the amp was on standby for 
> about 1 hour and it blew when I keyed up within the first 10 
> seconds. The bad thing --- I don't have a lot of knowledge of 
> electronics, just the basics. 
> Thanks
> Larry
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> 
>                 
> ---------------------------------
> Do you Yahoo!?
>  Yahoo! Mail - Easier than ever with enhanced search. Learn more.
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> 
> 


More information about the Amps mailing list